Spooler Utilities Reference Manual

Using FASTP
Spooler Utilities Reference Manual—522295-003
F-5
Extended Configuration With FASTCNFG
Extended Configuration With FASTCNFG
The FASTP print process can use a configuration file named FASTCNFG.

Instances of FASTP can share the same FASTPCNFG file.

Each FASTP print process must be instructed to read the FASTPCNFG file when it
is started.
To instruct FASTP to read the FASTCNFG file, set bit 5 of the PARAM device attribute (a
16-bit binary string) to 1.
If any other bits are set to 1, they must all be set with one PARM entry. Do not use
multiple PARM entries for one device.
If only bit 5 is set to 1, PARM would have a decimal value of 1024:
DEV $device-name, PARM 1024
Bit 0 is the most significant bit of the word.
Setmode Out SETMODE operation and two parameters sent to the device.
Supervisor - Batch
Status In
Response received from supervisor process containing status for a
batch.
Supervisor - Batch
Status Out
Request sent to supervisor process to solicit status of a batch.
Supervisor - Collector
Status In
Response received from supervisor process containing status for a
collector process.
Supervisor - Collector
Status Out
Request sent to supervisor process to solicit status of a collector
process.
Supervisor -
Command In
Command received (buffer contents) from the supervisor process.
Supervisor commands are logged only if the device is already
identified. For example, an OPEN command is not usually logged.
Supervisor - DEV
Status In
Response received from supervisor process containing status for a
device.
Supervisor - DEV
Status Out
Request sent to supervisor process to solicit status of a device.
Supervisor - Job
Status In
Response received from supervisor process containing status for a
job.
Supervisor - Job
Status Out
Request sent to supervisor process to solicit status of a job.
Table F-1. Types of Trace File Events and Data (page 2 of 2)
Event Identifier
From First Record
for Trace Event Contents of Second Record for Trace Event