SQL/MP Messages Manual

SQLCI Utility Processor Messages (9000 to 9999)
HP NonStop SQL/MP Messages Manual—427720-006
11-8
SQL 9026
Cause. The error code returned to LOAD, APPEND, APPENDRESTART, or
APPENDCANCEL by the SQL loader was outside the range of valid error codes.
Effect. The command fails. As a result, the target might be in an invalid state.
Recovery. If the target is marked invalid, try rerunning the command (if it was
APPEND, try APPENDRESTART or APPENDCANCEL), in case the failure was
temporary. If that does not work, report the entire message to your service provider.
SQL 9027
Cause. An I/O error occurred for the indicated dictionary file. The dictionary might
have been missing from the volume. See the file system error following this error for
more information.
Effect. The command fails.
Recovery. Correct the file system error condition.
SQL 9028
Cause. An error occurred during an attempt to perform the specified operation on the
named object. See the error following this error for more information.
Effect. The command fails.
Recovery. Analyze the accompanying message to determine the appropriate
corrective action. This error might be an internal error. If you suspect this, report the
entire message to your service provider.
9026 The value-1 operation failed on value-2. An unexpected
load error code was returned by the SQL loader. As a result,
value-2 might be in an invalid state.
9027 An error occurred when accessing dictionary file value-
1.
9028 value-1 DDL operation on value-2 failed.