SQL/MP Messages Manual

SQLCI Utility Processor Messages (9000 to 9999)
HP NonStop SQL/MP Messages Manual—427720-006
11-14
SQL 9047
Cause. The indicated file could not be purged, probably because of a security
violation. See the error message following this error for more information.
Effect. The PURGE command is not applied to this file. If the error limit in the
ALLOWERRORS option is reached, the command is terminated.
Recovery. Correct the file system error condition.
SQL 9048
Cause. The specified parameter is not allowed for SQL objects.
Effect. The command fails.
Recovery. Remove the indicated parameter, and enter the command again.
SQL 9049
Cause. The source file for the LOAD operation was empty, and the EMPTYOK option
was not specified in the command line.
Effect. The LOAD command fails.
Recovery. If EMPTYOK is appropriate, specify EMPTYOK. This option causes the
data to be purged from the target file and allows no new data to be written to the file.
SQL 9050
Cause. An invalid Subsystem Programmatic Interface (SPI) token for a qualified file
set was passed from SQLCI to SQLUTIL.
Effect. The command fails.
Recovery. None. Report the entire message to your service provider.
9047 Purging of value-1 has failed.
9048 The value-1 specification is not allowed for SQL
objects.
9049 There are no rows in value-1 to be loaded.
9050 The qualified fileset specification value-1 FROM CATALOG
value-1 is not valid.