SQL/MP Messages Manual
SQLCI Utility Processor Messages (9000 to 9999)
HP NonStop SQL/MP Messages Manual—427720-006
11-44
SQL 9148
Cause. PURGEDATA, PARTONLY option only applies to the last partition of an entry-
sequenced or relative table.
Effect. The PURGEDATA command fails.
Recovery. Correct the command. For the PURGEDATA, PARTONLY option, verify
that the object is the last partition of an entry-sequenced or relative table.
SQL 9150
Cause. The description of the index associated with the referential constraint could not
be found in the catalog. The keytag of the index is listed in the error message. A
keytag value of zero indicates that information about the primary key is missing.
Effect. The command terminates processing of the current table and continues with
the next table.
Recovery. None. Report the entire message to your service provider.
SQL 9151
Cause. The index that was specified in a config-file FOR index-name clause for the
parallel load index operation was not found.
Effect. The LOAD operation fails.
Recovery. If you believe the file exists, verify the file name and make any necessary
corrections before reissuing the command.
9148 The PURGEDATA command using the PARTONLY option cannot
operate on SQL table value-1 because the object is not the
last partition of an entry-sequenced or relative table.
9150 The catalog description for index keytag value-1 of
table value-2 could not be found.
9151 Index value-1 does not exist.