SQL/MP Messages Manual

SQLCI Messages (10000 to 10999)
HP NonStop SQL/MP Messages Manual—427720-006
12-61
SQL 10626
Cause. Stated in the error message.
Effect. The command fails.
Recovery. Reissue the command. If the error persists, contact your system manager.
SQL 10627
Cause. The system could not start or communicate with the SQL compiler
(SQLCOMP). The SQLCOMP module might have been missing, or there was a
security problem with SQLCOMP.
Effect. Cannot complete SQL compiling SQLCI2.
Recovery. If the SQLCOMP file is not present, install SQLCOMP. If SQLCOMP is not
licensed, license it by using the FUP LICENSE SQLCOMP command and reissue it. If
security is the problem, contact your system manager.
SQL 10628
Cause. This message has three possible causes:
•
The system could not start or communicate with the SQL compiler (SQLCOMP)
because the SQLCOMP module was missing or because there was a security
problem with SQLCOMP
•
SQLCOMP had insufficient disk space to open a swap file
•
The Binder version was wrong
Effect. The compilation fails.
Recovery. If the SQLCOMP file is not present, install SQLCOMP. If SQLCOMP is not
licensed, license it using the FUP LICENSE SQLCOMP command, and try again. If
security is the problem, contact your system manager. If SQLCOMP has insufficient
disk space, use the PARAM SWAPVOL command to specify a volume with more disk
space. If the Binder version is wrong, correct it.
10626 Process subtype is invalid.
10627 Unable to start SQL compiler value-1 during INITIALIZE
SQL. Reissue the command.
10628 Unable to communicate with the SQL compiler process
value-1.