SQL/MP Messages Manual

SQLCI Messages (10000 to 10999)
HP NonStop SQL/MP Messages Manual—427720-006
12-68
SQL 10655
Cause. See the file system error for the cause.
Effect. You cannot execute the INITIALIZE SQL command successfully or install
SQLCI2 on your system.
Recovery. Correct the file system error condition. If you cannot correct the condition,
contact your system manager.
SQL 10656
Cause. The SQLCI2 file was not found in the subvolume from which SQLCI was
started (by default $SYSTEM.SYSTEM). SQLCI and SQLCI2 must reside in the same
subvolume.
Effect. You cannot execute any SQL commands from SQLCI.
Recovery. If SQLCI2 was purchased by your installation, install it and reissue the
command. If you are executing SQLCI from a subvolume in which SQLCI2 is not
present, place SQLCI2 and SQLCI in one subvolume, SQL compile SQLCI2 and
reissue the command.
SQL 10657
Cause. See the catalog manager errors for the cause.
Effect. The DROP SYSTEM CATALOG command fails.
Recovery. Correct the catalog manager errors and reissue the command.
10655 Purge of SQLCI2 failed.
10656 The command is not executed because the SQL application
is not registered with NonStop SQL/MP Conversational
Interface (SQLCI). If you think that this command should be
executed through SQLCI, report the problem to your system
manager.
10657 The DROP SYSTEM CATALOG command failed. See the
associated errors from the catalog manager.