SQL/MP Messages Manual

SQL Catalog Manager Messages (1000 to 1999)
HP NonStop SQL/MP Messages Manual—427720-006
3-11
SQL 1074
Cause. A table or index that has a partition array value of "STANDARD" or
"EXTENDED" cannot have Format 2 partitions.
Effect. The statement fails.
Recovery. Reissue the statement without the FORMAT clause.
SQL 1080
Cause. The =_SQL_CAT_TIMEOUT DEFINE specified an invalid timeout value.
Effect. The Catalog Manager process will remain in inactive state for the default
timeout value.
Recovery. Change the timeout value to a legal value in the range of 0 to 720 minutes.
SQL 1103
Cause. A security violation occurred during your attempt to access the specified
catalog.
Effect. The statement fails.
Recovery. Check that you have sufficient authority to use catalogs involved in this
operation, and reissue the statement.
SQL 1104
Cause. A node specified in the statement was unknown or unavailable.
Effect. The statement fails.
Recovery. Check that the node specified is correct. If the statement is correct, wait
until the node becomes available and enter the statement again.
FORMAT 2 can only be specified if the partition array value
of the object is "FORMAT2ENABLED".
The inactivity timeout value specified for the Catalog
Manager process is invalid. The default value of ~1~ minute
will be used instead.
1103 You do not have sufficient authority to use catalog
value-1 to perform this operation.
1104 Unable to access an unknown or unavailable system.