SQL/MP Messages Manual

SQL Catalog Manager Messages (1000 to 1999)
HP NonStop SQL/MP Messages Manual—427720-006
3-33
SQL 1222
Cause. See the file system or disk process error following this error for the cause.
Effect. The statement fails.
Recovery. Correct the file system or disk process error condition and enter the
statement again.
SQL 1223
Cause. See the file system or disk process error following this error for the cause.
Effect. The statement fails.
Recovery. Correct the file system error or disk process error condition and enter the
statement again.
SQL 1224
Cause. The value for MAXEXTENTS was either out of range (accepted range is from
1 through 959), or an attempt was made to alter it below the number of extents
allocated, or see the file system or disk process error following this error for the cause.
Effect. The statement fails.
Recovery. Specify a value for MAXEXTENTS within the accepted range, or a value
higher than extents allocated, or correct the file system or disk process error condition
and enter the statement again.
SQL 1225
Cause. A DDL or utility operation involving the index view entry did not complete
successfully and left the index view entries in an inconsistent state.
Effect. The statement fails.
Recovery. Use the TMF subsystem to recover the index view entries or report the
entire message to your service provider.
1222 The label of value-1 could not be altered.
1223 The label of value-1 could not be dropped.
The maxextents value of 1 (CHAR) could not be altered.
1225 Unable to alter the label of value-1 because the index
view entry for value-2 is missing.