SQL/MX 2.x Messages Manual (G06.24+, H06.03+)

MXCI Messages (15000 through 15999)
HP NonStop SQL/MX Messages Manual—523730-004
14-54
Effect. The operation fails.
Recovery. Either specify an asterisk (*) wildcard for the EVAR name, or remove the
type ALL from EVAR object for this command.
SQL 15410
Where source-ds is the old data source where the EVARs will be copied from.
Where source-ds is the existing DS that defines the EVARs to be copied.
Where target-ds is the new data source where the EVARs will be copied to.
Where target-ds is the new data source being created.
Cause. A problem occurred in support routines during reading or writing to existing
EVARs. See the subsequent messages for details of the problem.
Effect. The command fails, removing the partially created new DS.
Recovery. Correct the problem described by the lower-level error messages and enter
the full command.
SQL 15411
Where evar-name is name of the EVAR specified in the command.
Where evar-type is the EVAR type specified in the command.
Cause. Incorrect command entry.
Effect. The operation fails.
Recovery. Check command input for EVAR type, EVAR name, or system.
SQL 15412
Where object-type is the object type specified on the command line.
Where duplicate-count is the number of duplicates found.
15410 Copying EVARs from source-ds data source to target-ds
data source failed.
15411 No EVAR named evar-name found in type evar-type.
+++SUGG: Perhaps type is wrong, name is spelled wrong, or
SYSTEM is wrong.
15412 The first object-type with this name was deleted, but
duplicate-count more duplicates were found. +++SUG: Run the
delete command again if more clean-up is needed.