SQL/MX 2.x Messages Manual (G06.24+, H06.03+)

MXCI Messages (15000 through 15999)
HP NonStop SQL/MX Messages Manual—523730-004
14-65
SQL 15514
Cause. The value that you specified in the LIST command was out of range. The
value must be in the range 1 through 32767, or ALL.
Effect. The operation fails.
Recovery. Specify the correct value and resubmit.
SQL 15515
Cause. When a SELECT operation is in progress, you can enter only certain MXCI
commands, such as report writer commands and:
ENV
EXIT|
RESET LAYOUT|REPORT|SESSION|STYLE FC
SET LAYOUT|SESSION|STYLE HELP
SHOW DEFINE|DEFMODE|LAYOUT|REPORT
INFO DEFINE|PARAM|SESSION|STYLE LOG
Effect. The operation fails.
Recovery. If you specified the command by mistake, enter the correct command. If
you wanted to enter the command, use the CANCEL command to terminate the
SELECT statement and reissue the command.
SQL 15516
Cause. You can enter these commands only when a SELECT is in progress:
BREAK
DETAIL
PAGE TITLE BREAK FOOTING
LIST
REPORT FOOTING BREAK TITLE
NAME
REPORT TITLE CANCEL
PAGE FOOTING
SUBTOTAL TOTAL
Effect. The operation fails.
15514 The value must be between 1 and 255 for the LIST
command.
15515 This command is not allowed because a SELECT is in
progress.
15516 This command is allowed only when a SELECT is in
progress.