SSH Reference Manual

This command always displays current information.
• GWN File name (or blank)
• Blocksize
• Next window name
• Last window name allocated (same as next if no GWN File)
• Maximum window number
If ALLOC is specified, a new block of session names is allocated from GWN^FILE. Since allocation is normally done
automatically, ALLOC is intended for development use only. Any window names reserved by a previous GWN^FILE
allocation but not yet used are discarded. The next session will begin with the number just allocated.
GWN Related EMS Events
EMS events are generated at GWN initialization, whenever allocations are made from GWN^FILE, and whenever any
errors occur. Refer to the section on EMS events.
SCF and SPI
STN provides limited support for SCF and SPI:
• SCF may not be used to configure STN; all configuration and control is done using STNCOM.
• The subset of SPI commands used by NonStop™ ASAP is supported
• INFO / STATUS / STATS PROC.
• INFO / STATUS / STATS / LISTOPENS WINDOW <window>. Only single window may be specified. “*” for
all windows is not supported.
Starting with B08, SPI INFO WIN returns an additional token ZSTN^TKN^SSH^PROC 1005 (see ZSTNDDL)
which contains the SSH process name for PTY sessions.
• STATS SERVICE <service>. Only single service may be specified. “*” for all services is not supported.
• NAMES SERVICE / WINDOW *
• NAMES (LISTOBJECTS) responses are limited to a single buffer with no error or continuation indication. SCF
NAMES WINDOW $STN.* will return approximately 150-200 window names.
• Some fields have different interpretations.
• Some additional tokens are present. SCF and NonStop™ ASAP ignore these. See ZSTNDDL.
SPI support in STN is limited to the commands used for NonStop™ ASAP. These commands can also be used from
SCF, but this is not recommended. STNCOM is required for all configuration and is recommended over SCF even for
those commands which are supported from SCF.
HP NonStop SSH Reference Manual STN Reference • 285