SSH Reference Manual

EMS Events
The STN installation subvolume contains standard EMS files which provide additional details:
• ZSTNDDL DDL for event names
• ZSTNTMPL template output file for EMSDIST
It is recommended that ZSTNTMPL be installed using standard procedures.
Note: In the following event descriptions, event name and number are given, followed by the EMS template for this
event. All references to <1> refer to the STN process that issued the event.
zstn-evt-stnlog value is 1003
"<1> STNLOG <2>"
<2> text
• CAUSE: STNLOG messages can be generated by other components and also by the STNCOM command
STNLOG. The text is described in the documentation for the component which generated the message.
• EFFECT: Refer to other documentation.
• RECOVERY: Refer to other documentation.
zstn-evt-application-loop value is 1018
"<1> STN Application <2> is looping on window <3>"
<2> name of application
<3> STN window name
• CAUSE: An application has repeatedly attempted to perform output to a terminated session. (See STNCOM
command REPLY_MAX_DELAY). The application process name and STN window name are displayed. This
message is displayed once per session.
• EFFECT: None.
• RECOVERY: Review the application for proper error handling.
zstn-evt-auditcoll-start value is 1020
"<1> AUDITCOLL started to collector <2> version <3>"
<2> name of AUDITCOLL collector
<3> STN version and release date
• CAUSE: STNCOM command AUDITCOLL was used to open an EMS collector. This event is written to the
specified collector, not to the standard $0 EMS event collector.
• EFFECT: Audit-type events will be written to the specified collector.
• RECOVERY: None; informational only.
zstn-evt-auditcoll-stop value is 1021
286 • STN Reference HP NonStop SSH Reference Manual