SSH Reference Manual

• EFFECT: None.
• RECOVERY: None; informational only.
zstn-evt-auditcoll-disconnect value is 1025
"<1> AUDITCOLL disconnect <2> <3> <4>"
<2> full name of the window (\node.#stn.#window).
<3> remote IP address.
<4> remote IP port.
• CAUSE: A session has terminated. This event is written to the specified AUDITCOLL collector, not to the
standard $0 EMS event collector.
• EFFECT: None.
• RECOVERY: None; informational only.
zstn-evt-auditcoll-wsinfo value is 1026
"<1> AUDITCOLL <2> <3> <4> wsinfo <5> Outcome <6>"
<2> full name of the window (\node.#stn.#window),
<3> remote IP address.
<4> remote IP port.
<5> WSINFO text received from the workstation, if any.
<6> text "GRANTED" or "DENIED".
• CAUSE: WSINFO is set to REQUIRED or MATCH for a 6530 session. The information returned by the
workstation is given, and the outcome is GRANTED if the session was allowed to continue or DENIED if the
WSINFO requirements were not met. This event is written to the specified AUDITCOLL collector, not to the
standard $0 EMS event collector.
• EFFECT: None.
• RECOVERY: None; informational only.
zstn-evt-max-outq value is 1027
"<1> STN window <2> exceeds max_outq <3>"
<2> name of window
<3> maximum number of queued output messages
• CAUSE: The number of queued output messages for a session exceeded the limit given by STNCOM command
MAX_OUTQ. This is unusual application behavior.
• EFFECT: The session is terminated.
• RECOVERY: If the problem persists, contact Support.
zstn-evt-stop-process value is 1028
288 • STN Reference HP NonStop SSH Reference Manual