SSH Reference Manual

zstn-evt-starting value is 3
"<1> <2> program starting <3>"
<2> program name and version information
<3> additional copyright information
• CAUSE: The STN process has started.
• EFFECT: None.
• RECOVERY: None; informational only.
zstn-evt-param-error value is 4
"<1> Error in PARAM <2> <3>"
<2> parameter name
<3> value
• CAUSE: During STN startup, an error was found.
• EFFECT: The param is ignored, and STN startup proceeds without the param. Depending on the param, STN
may not operate properly.
• RECOVERY: If the parameter is important, correct the error, then stop and restart STN.
zstn-evt-gftcom-start-err value is 5
"<1> Error <2> <3> starting GFTCOM^OBJECT <4>"
<2> error code
<3> detail error
<4> program name
• CAUSE: PARAM GFTCOM^OBJECT was specified but an error was encountered when trying to start the
program indicated.
• EFFECT: The param is ignored, and STN startup proceeds without the parameter. Since this command is
generally used for essential configuration commands, STN will probably not operate properly.
• RECOVERY: Correct the error, then stop and restart STN, or use STNCOM command to directly enter any
required configuration commands.
zstn-evt-backup-started value is 6
"<1> Backup created in cpu <2>"
<2> cpu number
• CAUSE: STN created a backup process (a) after startup time when PARAM BACKUP is used, (b) after
STNCOM BACKUPCPU command, (c) after a takeover, or (d) after a backup CPU became available.
• EFFECT: STN is now operating with a backup process.
• RECOVERY: None; informational only.
292 • STN Reference HP NonStop SSH Reference Manual