SSH Reference Manual

zstn-evt-trace-size-file value is 20
"<1> PARAM TRACE^SIZE must precede PARAM TRACE^FILE"
• CAUSE: PARAM TRACE^SIZE followed PARAM TRACE^FILE
• EFFECT: PARAM TRACE^SIZE is ignored, so the trace file is opened with the default size.
• RECOVERY: Reorder the PARAM list. STNCOM commands can be used to stop and restart the trace using
the desired size without shutting down STN.
zstn-evt-reply-error value is 21
"<1> Reply error <2>"
<2> error code
• CAUSE: An unexpected file system error was returned by REPLYX.
• EFFECT: Usually none, unless other errors are noted.
• RECOVERY: If the problem persists, contact Support.
zstn-evt-stopping value is 22
"<1> Process stopping - SHUTDOWN command"
• CAUSE: The STNCOM command SHUTDOWN was entered.
• EFFECT: The STN process terminates. The backup process, if any, is stopped first. Any active sessions are
immediately terminated.
• RECOVERY: Restart STN.
zstn-evt-cpuswitch value is 23
"<1> Primary process stopping - CPUSWITCH command"
• CAUSE: The STNCOM command CPUSWITCH was entered.
• EFFECT: A backup takeover occurs, and the old primary becomes the new backup.
• RECOVERY: None; informational only.
zstn-evt-enter-debug value is 24
"<1> Process entering debug"
• CAUSE: The STNCOM command DEBUG was entered.
• EFFECT: The STN process enters inspect/debug at its current home terminal. This will suspend all STN
operation and can timeout any active sessions if the debug state is not exited within a short time.
• RECOVERY: The DEBUG command is generally used only by development and support staff.
296 • STN Reference HP NonStop SSH Reference Manual