SSH Reference Manual

Log messages are written the given device (e.g. $DEV.#SUBDEV).

Default

By default, no audit messages will be written ("*").

Considerations

• Although it is possible to specify a collector setting AUDITCONSOLE to a collector name is not recommended

because a collector will cut long messages after 108 characters.

• If writing audit messages to a collector is required, then use parameter AUDITEMS

instead.

See also

• AUDITEMS, AUDITFILE, AUDITFORMATCONSOLE

• "Audit Messages" in chapter "Monitoring and Auditing"

AUDITEMS

Use this parameter to define whether SSH2 audit messages are written to EMS.

Parameter Syntax

AUDITEMS collector | *

Arguments

Means that no audit messages are written to EMS.

collector

Specifies the name of the collector to which audit messages are written.

Default

By default, no audit messages are written to EMS ("*").

Considerations

• The AUDITFORMATEMS

parameter controls the log message format.

• The parameter can be changed without having to restart SSH2, using the SSHCOM command interpreter

(command SET AUDITEMS).

• To send audit messages to the default collector $0 use AUDITEMS $0.

• If the EMS collector specified cannot be opened during startup, SSH2 will write to the collector $0.

• If the EMS collector cannot be opened after it has been changed through SSHCOM, the original collector will

stay active.