SSH Reference Manual

On the other hand when BURSTSUPPRESSION is FLASE the log targets settings, enabled via target specific boolean

parameters called EMSBURSTSUPPRESSION, CONSOLEBURSTSUPPRESSION, FILEBURSTSUPPRESSION

and

CACHEBURSTSUPPRESSION are used.

When BURSTSUPPRESSION is TRUE and the BURSTSUPPRESSIONMAXLOGLEVEL is smaller than the log level

assigned to a log message, then duplicates of that log message (targets of either cache, console, EMS or file) are not

suppressed.

Default

If omitted, BURSTSUPPRESSION is set to FALSE.

Example

BURSTSUPPRESSION TRUE

See also

BURSTSUPPRESSIONEXPIRATIONTIME, BURSTSUPPRESSIONMAXLOGLEVEL

CACHEBURSTSUPPRESSION, CONSOLEBURSTSUPPRESSION, EMSBURSTSUPPRESSION and

FILEBURSTSUPPRESSION

BURSTSUPPRESSIONEXPIRATIONTIME

Use this parameter to configure at what interval log burst suppression, for log messages of all log targets (EMS, Console,

File and Cache), expires before a duplicate log messages is logged again.

Parameter Syntax

BURSTSUPPRESSIONEXPIRATIONTIME number-of-seconds

Arguments

number-of-seconds

Specifies the BURSTSUPPRESSIONEXPIRATIONTIME interval in seconds not to log duplicate log

messages.

Considerations

BURSTSUPPRESSION or one of the log target specific parameters CACHEBURSTSUPPRESSION,

CONSOLEBURSTSUPPRESSION, EMSBURSTSUPPRESSION and FILEBURSTSUPPRESSION need to be set to

TRUE; otherwise the value of BURSTSUPPRESSIONEXPIRATIONTIME is ignored.

Default

If omitted, BURSTSUPPRESSIONEXPIRATIONTIME is set to 300.

Example

BURSTSUPPRESSIONEXPIRATIONTIME 240