SSH Reference Manual

Parameter Syntax
IPMODE ip-mode
Arguments
ip-mode
The IP mode the SSH2 process will be running in. The following IP modes are supported:
o IPV4 – TCP/IP version 4 is supported only
o IPV6 – TCP/IP version 6 is supported only
o DUAL – Both TCP/IP versions 4 and 6 are supported
Default
The default value for this parameter is IPV4.
Example
IPMODE IPv6
Considerations
• The IPMODE parameter of SSH2 corresponds to the TCP/IP monitor process option FAMILY. The
configuration of SSH2 parameter SUBNET
or define =TCPIP^PROCESS^NAME must not contradict the value
of IPMODE, i.e. if IPMODE is set to IPv4, then the TCP/IP process cannot be configured with FAMILY IPv6
and vice versa.
• Similarly, the configuration of SSH2 parameters INTERFACE and INTERFACEOUT must be set consistently
with setting of parameter IPMODE.
See also
SUBNET, INTERFACE, INTERFACEOUT
LICENSE
Use this parameter to specify a different location for the SSH2 license file.
Note: If you purchased NonStop SSH with the NonStop™ Operating System Kernel for H Series and J Series
NonStop™ platforms, you will not need a license file anymore.
Parameter Syntax
LICENSE file
Arguments
file
Specifies the name of the SSH2 license file.
Considerations
• If the file name is not fully qualified, SSH2 will add the home subvolume of the object file to the file name.
• A license is no longer required for TNS/E systems. If a license file exists, then the customer name will be
extracted from it.
• Please see the section on the HOSTKEY
parameter for more information on the interaction of the license file
with the host key file.
88 • Configuring and Running SSH2 HP NonStop SSH Reference Manual