Storage Management Foundation User's Guide

COUP and PUP Interfaces
HP NonStop Storage Management Foundation User's Guide—523562-008
B-46
REDEFINEVIRTDISK Command
attribute-parameter
is any of the attribute parameters described under Storage Pool Attribute Set on
page B-27. The following rules govern attribute value changes for the AUDIT and
MIRROR attributes:
REDEFINEVIRTDISK Command
The REDEFINEVIRTDISK command modifies the attributes of a virtual disk. $ZSMS
must be in the UP execution state, and its catalog must be accessible. Only members
associated with the super-group (255,n) can execute the REDEFINEVIRTDISK
command. New values are valid when the process is restarted.
$virtual-disk-name
is the name of the virtual disk. It must have the same name as a virtual disk
process that has an OSCONFIG entry.
attribute-parameter
is one of the attribute parameters described under Virtual Disk Attribute Set
on
page B-29.
SHOWPOOL Command
The SHOWPOOL command retrieves information about the attributes of one or all
defined storage pools on a system. $ZSMS must be in the UP execution state, and its
catalog must be accessible. You need no special privileges to execute the
SHOWPOOL command.
Changing This
Value To This Value Is Valid
D[ISALLOWED] A[LLOWED] Always
D[ISALLOWED] R[EQUIRED] When the storage pool is empty
A[LLOWED] D[ISALLOWED] If any physical volumes do not have that
attribute associated with it
A[LLOWED] R[EQUIRED] If all physical volumes have that attribute
associated with it
R[EQUIRED] D[ISALLOWED] When the storage pool is empty
R[EQUIRED] A[LLOWED] Always
REDEFINEVIRTDISK $virtual-disk-name [,attribute-parameter]...
SHOWPOOL [$storage-pool-name]