Subsystem Control Point (SCP) Management Programming Manual

Commands and Responses
Subsystem Control Point (SCP) Management Programming Manual—520619-001
5-34
SWITCH Command
SWITCH Command
ZCOM-CMD-SWITCH (sensitive)
The SWITCH command causes the backup process of an SCP process pair to take over.
ZCOM-TKN-SWITCH-CPU
specifies the CPU in which the backup process—soon to be primary—is running.
This information is available from the STATUS command or the
LOOKUPPROCESSNAME or PROCESS_GETPAIRINFO_ procedures.
Command
ZCOM-CMD-SWITCH
Object Type
ZCOM-OBJ-PROC
SWITCH Command Tokens
ZSPI-TKN-MANAGER token-type ZSPI-TYP-FNAME32
or
ZCOM-TKN-XMGR token-type ZSPI-TYP-STRING
or
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-MAP-REQID
or
ZCOM-TKN-REQID-desc
ZCOM-TKN-CMD-TIMEOUT token-type ZSPI-TYP-TIMESTAMP
ZCOM-TKN-SWITCH-CPU token-type ZSPI-TYP-INT
ZSPI-TKN-RESPONSE-TYPE token-type ZSPI-TYP-ENUM
ZSPI-TKN-ALLOW-TYPE token-type ZSPI-TYP-ALLOW-TYPE
ZSPI-TKN-COMMENT token-type ZSPI-TYP-STRING
SWITCH Response Tokens
ZSPI-TKN-DATALIST token-type ZSPI-TYP-LIST
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZSPI-TKN-RETCODE token-type ZSPI-TYP-INT
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL