Subsystem Control Point (SCP) Management Programming Manual

Errors

Subsystem Control Point (SCP) Management Programming Manual—520619-001

A-7

–991 ZCOM-ERR-RCB-FULL

The SCP process request control block table is full.

Cause. All command-message control blocks are in use. Your communications

management application has one command message being processed and 15 command

messages pending, and it has attempted to issue another command message.

Effect. The SCP process cannot queue any more command messages until a control

block becomes available. This command message cannot be queued and is rejected by

the SCP process.

Recovery. Wait a few moments and reissue the command, or start an additional SCP

process and route the command through it.

–992 ZCOM-ERR-SCB-FULL

The SCP process communications subsystem open control block table is full.

Cause. All 256 subsystem open control blocks in the server control block (SCB) table

are in use. The SCP process cannot open any more communications subsystems until a

control block becomes available. See the description of the related event ZSCP-EVT-

SCB-FULL.

Effect. The SCP process rejects the command message.

Recovery. Wait a few moments and reissue the command, or start an additional SCP

process and route the command through it.

ZSPI-TKN-ERRLIST

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR

ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING

ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM

ZSPI-TKN-ENDLIST

Corresponding SCF Error Message