Subsystem Control Point (SCP) Management Programming Manual

Errors

Subsystem Control Point (SCP) Management Programming Manual—520619-001

A-20

–812 ZTRC-ERR-FUNC-INV

A collector process detected an invalid tracing function in a request.

TRC-TKN-INIT-ERR-DETAIL

is included in the error list generated by an SCP process. It is not applicable to this

error and is set to 0.

Cause. The SCP process sent an invalid tracing function to the collector.

Effect. The request is rejected.

Recovery. This is an internal SCP problem. Notify your Compaq representative.

–814 ZTRC-ERR-NOT-ACTV

A command to stop or alter tracing was received, but no trace was in progress.

ZTRC-TKN-INIT-ERR-DETAIL

is included in the error list generated by an SCP process. It is not applicable to this

error and is set to 0.

Cause. An SCP process received a request to stop or alter tracing while the process was

not engaged in trace activity. The original TRACE command might have failed, the

command message to alter or stop trace activity might have been sent to the wrong SCP

process, or trace activity might already have successfully completed.

Effect. The command is not completed. No trace is active.

ZSPI-TKN-ERRLIST

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR

ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM

ZCOM-TKN-OBJNAME <1> token-type ZSPI-TYP-STRING

ZTRC-TKN-INIT-ERR-DETAIL <2> token-type ZSPI-TYP-INT

ZSPI-TKN-ENDLIST

Corresponding SCF Error Message

Invalid trace function specified for <1> [; Detail = <2>]