Subsystem Control Point (SCP) Management Programming Manual

Errors
Subsystem Control Point (SCP) Management Programming Manual—520619-001
A-23
–834 ZTRC-ERR-SEG-ALLOC
Cause. This is an operating system problem.
Effect. Trace data might be lost.
Recovery. Contact your Compaq representative.
–834 ZTRC-ERR-SEG-ALLOC
An extended data segment, used for storing trace information, could not be allocated.
ZTRC-TKN-INIT-ERR-DETAIL
contains the ALLOCSEGMENT or SEGMENT_ALLOCATE_ procedure error. If it
is nonzero, a USESEGMENT procedure call failed.
Cause. This is usually caused by a disk space shortage.
Effect. The request is rejected.
Recovery. Free additional space on the swap volume or restart the SCP process
specifying a swap volume where there is adequate disk space.
–835 ZTRC-ERR-SEG-UNAVAIL
An extended data segment allocated for trace processing was unavailable for processing.
ZTRC-TKN-INIT-ERR-DETAIL
is included in the error list generated by an SCP process. It is not applicable to this
error and is set to 0.
Cause. This is an operating system problem.
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZCOM-TKN-OBJNAME <1> token-type ZSPI-TYP-STRING
ZTRC-TKN-INIT-ERR-DETAIL <2> token-type ZSPI-TYP-INT
ZSPI-TKN-ENDLIST
Corresponding SCF Error Message
Unable to allocate the trace segment for <1> [; Detail = <2>]
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZTRC-TKN-INIT-ERR-DETAIL <1> token-type ZSPI-TYP-INT
ZSPI-TKN-ENDLIST
Corresponding SCF Error Message
Trace segment is inaccessible [; Detail = <1>]