Subsystem Control Point (SCP) Management Programming Manual

Errors
Subsystem Control Point (SCP) Management Programming Manual—520619-001
A-25
–841 ZTRC-ERR-DEV-NOT-FOUND
Effect. The request is rejected.
Recovery. Correct the device name and reissue the request.
–841 ZTRC-ERR-DEV-NOT-FOUND
The device specified by ZSPI-TKN-MANAGER or ZCOM-TKN-OBJNAME in the
TRACE command could not be found.
Cause. The SCP process did not process the command message because the name
specified by the ZSPI-TKN-MANAGER or ZCOM-TKN-OBJNAME token is not an entry
in the operating system’s logical-device name table. The requester might be trying to
trace the backup process of an object that has no backup.
Effect. The request is rejected.
Recovery. Verify the name of the device and reissue the request. If the error recurs,
check with system management.
–845 ZTRC-ERR-FCODE-INV
The file code associated with the disk file specified for trace information is not 0.
ZTRC-TKN-INIT-ERR-DETAIL
is included in the error list generated by an SCP process. It is not applicable to this
error and is set to 0.
Cause. The specified trace file has the wrong file code.
Effect. The request is rejected.
Recovery. Provide a file with file code 830 and reissue the request.
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZCOM-TKN-OBJNAME <1> token-type ZSPI-TYP-STRING
ZSPI-TKN-ENDLIST
Corresponding SCF Error Message
Unable to find trace device for <1>
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZTRC-TKN-INIT-ERR-DETAIL <1> token-type ZSPI-TYP-INT
ZSPI-TKN-ENDLIST
Corresponding SCF Error Message
Trace file has invalid file code (not 830)[; Detail = <1>]