Subsystem Control Point (SCP) Management Programming Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

171

172

173

174

175

176

177

178

179

180

Errors

Subsystem Control Point (SCP) Management Programming Manual—520619-001

A-33

–859 ZTRC-ERR-INTR-NOT-RECVD

The subsystem failed to start a trace that was prepared by the collector.

ZTRC-TKN-INIT-ERR-DETAIL

is included in the error list generated by an SCP process. It is not applicable to this

error and is set to 0.

Cause. The collector process prepared the tracing environment and then waited an hour

without receiving a call from the subsystem to start the trace.

Effect. The collector issues this event and then stops.

Recovery. Restart the subsystem and retry the trace request. If the problem recurs,

contact your Compaq representative.

–860 ZTRC-ERR-COLL-RCV-FILE-ERR

The trace collector process encountered an error reading from or writing to its

$RECEIVE file.

ZTRC-TKN-INIT-ERR-DETAIL

contains the file-system error if available.

Cause. The collector got a file-system error while trying to read from or write to its

$RECEIVE file.

Effect. No trace is initiated. The collector issues this event and stops.

ZSPI-TKN-ERRLIST

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR

ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM

ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING

ZTRC-TKN-INIT-ERR-DETAIL <1> token-type ZSPI-TYP-INT

ZSPI-TKN-ENDLIST

Corresponding SCF Error Message

TRACE collector did not receive go-ahead interrupt

[; Detail = <1>]