Subsystem Control Point (SCP) Management Programming Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

171

172

173

174

175

176

177

178

179

180

Errors

Subsystem Control Point (SCP) Management Programming Manual—520619-001

A-34

–861 ZTRC-ERR-TRC-RCV-FILE-ERR

Recovery. Retry the request. If the problem recurs, contact your Compaq

representative.

–861 ZTRC-ERR-TRC-RCV-FILE-ERR

The SCP process detected an error trying to write to or read from its $RECEIVE file.

ZTRC-TKN-INIT-ERR-DETAIL

contains the file-system error if available.

Cause. The SCP process (or the process that called DSM_TRACE_INIT_) encountered

a file system error while trying to write to or read from its receive file.

Effect. No trace is initiated.

Recovery. Retry the request. If the problem recurs, contact your Compaq

representative.

–862 ZTRC-ERR-TRACE-FILE-SIZE

The trace file cannot contain the amount of data specified by the PAGES parameter.

ZTRC-TKN-INIT-ERR-DETAIL

is included in the error list generated by an SCP process. It is not applicable to this

error and is set to 0.

Cause. The trace file is not large enough to contain the amount of data requested by the

PAGES parameter.

Effect. The trace is not initiated.

ZSPI-TKN-ERRLIST

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR

ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM

ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING

ZTRC-TKN-INIT-ERR-DETAIL <1> token-type ZSPI-TYP-INT

ZSPI-TKN-ENDLIST

Corresponding SCF Error Message

TRACE PROCEDURE’s $RECEIVE file error; File System error: <1>