Subsystem Control Point (SCP) Management Programming Manual

Commands and Responses
Subsystem Control Point (SCP) Management Programming Manual—520619-001
5-17
INFO Command
.ZBKUP-CPU
reports the current backup CPU number. The backup process might not be
running. If it is not, this value specifies where the backup runs when initiated.
.ZBUF-SWAPVOL
specifies the name of the disk volume to which the data space (stack space) is
swapped. This value is assigned by the SWAP argument in the startup command
issued to a command interpreter when the program is initiated. If no SWAP
argument is given, Guardian assigns the swap volume to the same volume on
which the program runs. The backup process uses the same swap volume.
.ZMEM-SWAPVOL
reports the name of the disk volume to which general memory (extended
memory) is swapped. This value is specified by the SWAPVOL startup
parameter.
ZCMK-TKN-PRI-CPU
identifies the primary CPU in use by the SCP process.
ZCMK-TKN-PROG-FILE-MOD
records the modification timestamp of the SCP object program file.
ZCMK-TKN-PROG-XFNAME
identifies the object file of the SCP process.