SWAN 2 Concentrator Installation and Support Guide

Contents
SWAN 2 Concentrator Installation and Support Guide—429593-010
viii
Examples (continued)
Examples (continued)
Example 4-3. Aborting a CLIP 4-5
Example 4-4. Starting a CLIP 4-5
Example 4-5. Starting DLC TASK Objects 4-5
Example 4-6. Starting WAN Lines 4-6
Example 13-1. Sample X25AM Subsystem SCF ABORT LINE Command 13-3
Example 13-2. Sample SCF STOP ADAPTER Command 13-4
Example 13-3. Sample SCF ALTER ADAPTER Command to Alter Track-ID 13-4
Example 13-4. Sample SCF START ADAPTER Command 13-7
Example 13-5. Sample SCF START DEVICE Command 13-7
Example 13-6. Sample SCF START LINE Command 13-7
Figures
Figure 1-1. SWAN 2 Concentrator Front Panel With Components Labeled 1-3
Figure 1-2. SWAN 2 Concentrator Back Panel With Components Labeled 1-4
Figure 1-3. SWAN 2 Concentrator Physical Label 1-4
Figure 1-4. Track ID and MAC Address Label 1-5
Figure 2-1. Connecting SWAN 2 Concentrators Using Ethernet Switches or
Hubs 2-19
Figure 2-2. Connecting SWAN 2 Concentrators Using Cascaded Ethernet Switches
or Hubs 2-20
Figure 2-3. 50-Pin Connector on One End of All Interface Converter Cables 2-29
Figure 2-4. Interface-Specific Connectors on the Other End of Interface Converter
Cables 2-30
Figure 2-5. Status LEDs on the Front Panel 2-33
Figure 2-6. Status LEDs on the Back Panel 2-33
Figure 2-7.
LAN BIC Status LEDs Close-up View 2-34
Figure 7-1.
WAN BICs 7-3
Figure C-1. RJ-45 Connector Pin Numbering on SWAN 2 Concentrator C-2
Figure C-2. RS-232 Cable Design C-4
Figure C-3. RS-449 Cable Design C-6
Figure C-4. X.21 Cable Design C-8
Figure C-5. Schematic Representation of the V.35 Wire List C-10
Figure C-6. V.35 Cable Design Wire List C-11
Figure C-7. 50-Pin Connector on One End of All Interface Converter Cables C-13
Figure C-8. Interface-Specific Connectors on Other End of Interface Converter
Cables C-14
Figure C-9. Driver and Receiver Multiplexer and Selection Circuitry C-15
Figure D-1. SWAN 2 Concentrator to Current Loop Device Configuration D-1
Figure D-2. SWAN 2 Concentrator to Current Loop Cable Configuration D-1