SWAN 2 Concentrator Installation and Support Guide

Replacing a WAN Backplane Interface Card (BIC)

SWAN 2 Concentrator Installation and Support Guide—429593-010

7-2

Gather the Proper Tools

You will need the following tools to replace a WAN BIC:

Determine the Physical Location of the WAN BIC

To determine the physical location of the WAN BIC to be replaced, use the OSM

Service Connection or TSM Service Application:

1. In the display pane of the Management window, select the SWAN 2 concentrator

containing the WAN BIC to be replaced.

2. Click the Attributes tab in the details pane to determine the Track ID of that

SWAN 2 concentrator.

3. Physically locate the SWAN 2 concentrator that has this Track ID on the back

panel of its chassis (see Figure 1-4 on page 1-5).

4. WAN BICs are located on the back panel of a SWAN 2 concentrator, and each

WAN BIC is labeled (see Figure 7-1 on page 7-3).

Tool Used to...

Electrostatic discharge (ESD) protection kit Protect electronic components against

damage caused by electrostatic discharge

Utility knife Cut packing tape

Flashlight Inspect WAN BIC edges