SWAN 2 Concentrator Installation and Support Guide

Replacing a LAN Backplane Interface Card (BIC)

SWAN 2 Concentrator Installation and Support Guide—429593-010

9-2

Gather the Proper Tools

You will need the following tools to replace a LAN BIC:

Determine the Physical Location of the LAN BIC

To determine the physical location of the LAN BIC to be replaced, use the OSM

Service Connection or TSM Service Application:

1. In the tree pane of the Management window, select the SWAN 2 concentrator

containing the LAN BIC to be replaced.

2. Click the Attributes tab in the details pane to determine the Track ID of that

SWAN 2 concentrator.

3. Physically locate the SWAN 2 concentrator that has this Track ID on the back

panel of its chassis (see Figure 1-4 on page 1-5).

4. LAN BICs are located on the back panel of the SWAN 2 concentrator, and each

LAN BIC is labeled (see the figure on the following page).

Replace the LAN BIC

Review Standard Operating Practices

Refer to Standard Operating Practices on page 5-3.

Tool Used to...

Electrostatic discharge (ESD) protection kit Protect electronic components against

damage caused by electrostatic discharge

Utility knife Cut packing tape

Flashlight Inspect LAN BIC edges

Table 9-2. Replacement Checklist for a LAN BIC

Step Description

Review Standard Operating Practices.

Remove the LAN BIC.

Unpack and Inspect the Replacement LAN BIC.

Install the Replacement LAN BIC.

Verify the Installation of the Replacement LAN BIC

Note. Whenever you handle a LAN BIC, follow standard operating practices to avoid damage

to the equipment.