SWAN 2 Concentrator Installation and Support Guide

SWAN 2 Concentrator Installation and Support Guide—429593-010
13-1
13 Replacing a Chassis
Description of a Chassis
The chassis contains the midplane and the sheet metal for the other components.
Service Class
For the service class of a chassis, refer to Component Service Classes on page 5-1.
Prepare to Replace a Chassis
Gather the Proper Tools
You will need the following tools to replace a chassis:
Description of a Chassis Page 13-1
Service Class Page 13-1
Prepare to Replace a Chassis Page 13-1
Replace the Chassis Page 13-5
Resume Operations on the Chassis Page 13-7
WARNING. You must power off the SWAN 2 concentrator before replacing a chassis. It is
possible to incur a severe energy hazard if the concentrator is not powered off.
Table 13-1. Preparation Checklist to Chassis
Step Description
1. Gather the Proper Tools
.
2. Determine the Physical Location of the Chassis
.
3. Stop the Communication Lines Using the Associated SWAN 2 Concentrator
.
4. Stop and Reconfigure the Associated SWAN 2 Concentrator
5. Label the Communication Cables Connected to the Associated SWAN 2
Concentrator
Tool Used to...
Electrostatic discharge (ESD) protection kit Protect electronic components against
damage caused by electrostatic discharge
Slotted screwdriver Disconnect and reconnect the interface
converter cable to your cable