SWAN 2 Concentrator Installation and Support Guide

Replacing a Chassis
SWAN 2 Concentrator Installation and Support Guide—429593-010
13-2
Determine the Physical Location of the Chassis
Determine the Physical Location of the Chassis
Determine the physical location of the SWAN 2 concentrator containing the chassis to
be replaced by using the OSM Service Connection or the TSM Service Application:
1. In the tree pane of the Management window, select the SWAN 2 concentrator
containing the chassis to be replaced.
2. Click the Attributes tab in the details pane to determine the Track ID of that
SWAN 2 concentrator.
3. Physically locate the SWAN 2 concentrator that has this Track ID on the back
panel of its chassis (see Figure 1-4 on page 1-5).
4. The chassis is within this “associated” SWAN 2 concentrator (see the following
figures).
Torx T-25 screwdriver Loosen and tighten concentrator screws
Utility knife Cut packing tape
Wire cutters Cut cable ties
Tool Used to...