SWAN 2 Concentrator Installation and Support Guide

Using OSM to Update SWAN 2 CLIP Firmware
SWAN 2 Concentrator Installation and Support Guide—429593-010
A-4
Step 4: Refresh the Status of All SWAN 2 Batteries
c. Correct the problem. See What to Do if OSM Fails to Update a CLIP on
page 4-6. If you still have problems with the update of a SWAN CLIP, see the
SWAN Concentrator and WAN Subsystem Troubleshooting Manual, Section 4.
8. When the SWAN CLIPs have been updated, refresh all the SWAN 2 batteries
before starting the CLIPs.
Step 4: Refresh the Status of All SWAN 2 Batteries
Skip this step if you have not updated T7954 AAN or earlier firmware to T7954 AAP or
later firmware. If you have updated T7954 AAN or earlier firmware to T7954 AAP or
later firmware, ask your authorized service provider to review Support Note S10029
before proceeding to Step 5.
Step 5: Start the SWAN Concentrator and CLIPs
1. With the Multi-Resource Actions dialog box still open, from the Action list, select
Start.
2. Click Add or Add all.
3. Click Perform Action.
The SWAN CLIPs should start. If they do not, see the SWAN Concentrator and WAN
Subsystem Troubleshooting Guide, Section 4. You can also use SCF to start the CLIP
or use the Actions - CLIP dialog box.