SWAN 2 Concentrator Installation and Support Guide

About This Guide
SWAN 2 Concentrator Installation and Support Guide—429593-010
xiv
What’s in This Guide
What’s in This Guide
Table i summarizes the contents of this guide.
Table i. Contents of This Guide (page 1 of 2)
Section or
Appendix Title Contents
1 Introduction to the
SWAN 2
Concentrator
Provides a high-level overview of the architecture and
components of the SWAN 2 concentrator.
2 Installing a SWAN 2
Concentrator
Describes how to install a SWAN 2 concentrator.
3 Replacing a
SWAN 2
Concentrator
Describes how to replace a SWAN 2 concentrator.
4 Diagnosing
Problems
Describes the tools that you use to diagnose SWAN 2
concentrator problems.
5 Servicing SWAN 2
Concentrator
Components
Describes the general procedures for servicing a
component in a SWAN 2 concentrator.
6 Replacing a
Communications
Line Interface
Processor (CLIP)
Describes how to replace a communications line
interface processor (CLIP) in a SWAN 2 concentrator.
7 Replacing a WAN
Backplane Interface
Card (BIC)
Describes how to replace a WAN backplane interface
card (BIC) in a SWAN 2 concentrator.
8 Replacing a LAN
Logic Board (LB)
Describes how to replace a LAN logic board (LB) in a
SWAN 2 concentrator enclosure
9 Replacing a LAN
Backplane Interface
Card (BIC)
Describes how to replace a LAN backplane interface
card (BIC) in a SWAN 2 concentrator.
10 Replacing a Power
Supply
Describes how to replace a power supply in a SWAN 2
concentrator.
11 Replacing a Battery
Describes how to replace a battery in a SWAN 2
concentrator.
12 Replacing a Fan
Describes how to replace a fan in a SWAN 2
concentrator.
13 Replacing a
Chassis
Describes how to replace a chassis in a SWAN 2
concentrator.
A Using OSM to
Update SWAN 2
CLIP Firmware
Describes how to use OSM to update the SWAN 2
firmware on a communications line interface processor
(CLIP).