SWAN 2 Concentrator Installation and Support Guide

Using TSM to Update SWAN 2 CLIP Firmware
SWAN 2 Concentrator Installation and Support Guide—429593-010
B-9
Step 4: Stop the SWAN 2 Concentrator and CLIPs
Verify That the CLIPs Are Stopped
Use the Attributes tab in the TSM Service Application or SCF command to check that
the SWAN concentrators and CLIPs are in the STOPPED state. For example, to see
the state of the SWAN 2 CLIPs using TSM:
Or (using SCF), enter:
2-> status server $zzwan.#s01.*
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.1
State :......... STOPPED
.
.
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.2
State :......... STOPPED
.
.
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.3
State :......... STOPPED
.
.
VST400.vsd