SWAN 2 Concentrator Installation and Support Guide

About This Guide
SWAN 2 Concentrator Installation and Support Guide—429593-010
xv
Related Manuals
Related Manuals
The SWAN 2 concentrator should be installed only after it has been configured. The
WAN Subsystem Configuration and Management Manual describes how to configure a
SWAN concentrator (T3880) and SWAN 2 concentrator (T3881).
The NonStop Firmware Matrices document covers RVU-specific information about
updating SWAN 2 firmware for H-series and J-series RVUs. See the G06.nn Software
Installation and Upgrade Guide for G-series RVUs.
Notation Conventions
Hypertext Links
Blue underline is used to indicate a hypertext link within text. By clicking a passage of
text with a blue underline, you are taken to the location described. For example:
This requirement is described under Backup DAM Volumes and Physical Disk
Drives on page 3-2.
General Syntax Notation
The following list summarizes the notation conventions for syntax presentation in this
guide.
UPPERCASE LETTERS. Uppercase letters indicate keywords and reserved words; enter
these items exactly as shown. Items not enclosed in brackets are required. For
example:
MAXATTACH
B Using TSM to
Update SWAN 2
CLIP Firmware
Describes how to use TSM to update the SWAN 2
firmware on a communications line interface processor
(CLIP).
C Cable
Specifications
Describes the supported electrical signals and the
wiring of cables and connectors provided by HP for
use with the SWAN 2 concentrator.
D Connecting a
Current Loop
Device
Describes how to connect a current loop device to a
SWAN 2 concentrator.
Table i. Contents of This Guide (page 2 of 2)
Section or
Appendix Title Contents