SWAN 2 Concentrator Installation and Support Guide

Safety and Compliance
SWAN 2 Concentrator Installation and Support Guide—429593-010
Statements-6
Important Safety Information
Important Safety Information
HP NonStop NS-Series Servers
Safety information can be accessed from the NTL home page: select HP Integrity
NonStop Server Safety and Compliance>Important Safety Information. A
document window containing a binder of safety information, in several languages,
appears. In the document window, click a document title to open the safety information
in another language. Local HP support can also help direct you to your safety
information.
HP NonStop S-Series Servers
The rest of this section describes the safety statements for the NonStop S-series
servers.
Customer Installation and Servicing of Equipment
The following statements pertain to safety issues regarding customer installation and
servicing of equipment described in this manual.
•
Keep door closed for normal operation.
•
The equipment must be installed near the receptacles for the power cords, and the
receptacles must be easily accessible to the user.
Applicability of Procedures, Instructions, and Examples
Caution. If this unit has more than one power supply cord. Disconnect all power supply cords
to completely remove power from this unit.
WARNING. Do not touch the DC power connector on the S7400/7x000/8x000 PMF CRU after
you have unplugged the DC power cable from the CRU. It is possible to incur a severe energy
hazard for as long as fifteen (15) seconds after unplugging the cable. You can make sure the
CRU is safe to remove by testing (by using a volt meter) before touching the pins on the DC
power connector.
WARNING. The procedures and instructions and the examples of procedures and instructions
found in this manual apply only to the system enclosures and components found in NonStop
S-series servers which are described in the NonStop S-series server documentation. Do not
attempt to use these instructions with any other HP NonStop system equipment. You can
determine that your system is a NonStop S-series server by reading the label that appears
inside each system enclosure on the CRU in slot 50 or 55. The label includes the product
number, 195x, 196x, 197x or 198x series where x is any number. Read the label before
proceeding with any procedure or instruction found in this manual.