SWAN 2 Concentrator Installation and Support Guide

SWAN 2 Concentrator Installation and Support Guide—429593-010
2-1
2
Installing a SWAN 2 Concentrator
Prepare to Install a SWAN 2 Concentrator
Complete and Verify the Software Configuration of the SWAN 2
Concentrator
Before installing a SWAN 2 concentrator, you must:
•
Complete your software configuration.
•
Verify that the SWAN 2 concentrator’s configuration track-ID matches the actual
configuration track-ID located on the SWAN 2 concentrator.
Refer to the WAN Subsystem Configuration and Management Manual for further
information about completing and verifying your software configuration.
Prepare to Install a SWAN 2 Concentrator Page 2-1
Install the SWAN 2 Concentrator Page 2-3
Note. For information about adding a SWAN 2 concentrator to an existing system using SCF
or WAN Wizard Pro, see the WAN Subsystem Configuration and Management Manual.
Table 2-1. Preparation Checklist to Install a SWAN 2 Concentrator
Step Description
1. Complete and Verify the Software Configuration of the SWAN 2 Concentrator
.
2. Plan Your Installation
.
3. Gather the Proper Tools
.
4. Review Standard Operating Practices
.
Note. All SWAN 2 concentrators ordered with a NonStop system are configured for you by HP
manufacturing. If you ordered a SWAN 2 concentrator without a system, you must configure
the SWAN 2 concentrator yourself.