SWAN 2 Concentrator Installation and Support Guide

Installing a SWAN 2 Concentrator
SWAN 2 Concentrator Installation and Support Guide—429593-010
2-9
Rack-Mount the SWAN 2 Concentrator
6. Once the rail is secure, place it back into the rack and use a T-25 Torx screwdriver
to tighten two M5 screws in the top and bottom of the rails on the front and back of
the rack.
7. Repeat Steps 4, 5, and 6 for installing the left rack-mount rail.
Rack-Mount the SWAN 2 Concentrator
The SWAN 2 concentrator is 3 units tall and must be rack-mounted in a 19-inch EIA
rack. Before rack-mounting the SWAN 2 concentrator, review the rack-mount
requirements in the following figure.
1. Preferably, two persons should lift and position the SWAN 2 concentrator into the
rack-mount rails. One person should push the SWAN 2 concentrator all the way
into the rack.
VST723.vsd