SWAN 2 Concentrator Installation and Support Guide

Installing a SWAN 2 Concentrator
SWAN 2 Concentrator Installation and Support Guide—429593-010
2-13
Connect the Ethernet Cables
Identify the Correct Ethernet Ports
Make sure that the Ethernet cables connected to Ethernet ports A and B on a SWAN 2
concentrator are connected to the correct ports on the adapters.
If you ordered this SWAN 2 concentrator with a NonStop BladeSystem, Integrity
NonStop NS-series, or NonStop S-series server, the adapters and the adapter ports
used to connect this SWAN 2 concentrator are preconfigured by HP manufacturing.
If you ordered this SWAN 2 concentrator without a server, you must configure the
adapters and adapter port connections to this SWAN 2 concentrator. Refer to the WAN
Subsystem Configuration and Management Manual for more information.
The following figure shows the Ethernet ports on an E4SA that connect to a SWAN 2
concentrator. The E4SA has four Ethernet ports labeled ENET 0A, ENET 0B, ENET
1A, and ENET 1B.
SAC 1
ENET 0B
ENET 0A
ENET 1A
ENET 1B
SAC
0
Ejector
Ethernet 4 ServerNet Adapter (E4SA)
RX
TX
COL
LNK
RX
TX
COL
LNK
RX
TX
COL
LNK
RX
TX
COL
LNK
Power-On LED (green)
Fault LED (amber)
Receive Data (green)
Transmit Data (green)
Collision Detect (green)
Link Integrity (green)
RJ-45 Connector
Ethernet
Hub
RJ-45
Connector
To Ethernet Port A or B on
the SWAN 2 Concentrator
VST860.vsd