SWAN 2 Concentrator Installation and Support Guide

SWAN 2 Concentrator Installation and Support Guide—429593-010
2-30
Connect the Interface Converter Cables to the WAN
Ports
To connect an interface converter cable:
1. Connect the interface-specific connector to the connector on the Ethernet cable.
2. Connect the 50-pin connector to the appropriate port on the SWAN 2 concentrator
and secure it by tightening the lock-down screws with a slotted screwdriver (finger
tight is usually sufficient).
Figure 2-4. Interface-Specific Connectors on the Other End of Interface
Converter Cables
RS-232 DB-25
Top View
Side View
RS-449 DB-37
Side View
V.35 34-Pin Connector
Side View
X.21 DB-15
Side View
Top View
Top View Top View
VST835.vsd