SWAN 2 Concentrator Installation and Support Guide

SWAN 2 Concentrator Installation and Support Guide—429593-010
2-36
Power On the SWAN 2 Concentrator and Run the
Power-On Self-Test (POST)
5. Fasten and tighten the cable ties to prevent accidental unplugging of the AC power
cords. Make sure the cable ties are not so tight that you cannot easily remove the
AC power cords.
6. Repeat Steps 2, 3, 4, and 5 to connect the second AC power cord.
Troubleshooting Abnormal LED States
Table 2-5 describes corrective actions for abnormal LED states. If you have installation
problems that are not solved after using Table 2-5, see Section 4, Diagnosing
Problems.
VST980.vsd
Cable Ties