SWAN 2 Concentrator Installation and Support Guide

SWAN 2 Concentrator Installation and Support Guide—429593-010
3-1
3
Replacing a SWAN 2 Concentrator
Prepare to Replace a SWAN 2 Concentrator
Gather the Proper Tools
You will need the following tools to replace a SWAN 2 concentrator:
Prepare to Replace a SWAN 2 Concentrator Page 3-1
Replace the SWAN 2 Concentrator Page 3-3
Resume Operations on the SWAN 2 Concentrator Page 3-6
Note. Whenever you handle a SWAN 2 concentrator, follow standard operating practices to
avoid damage to the equipment. See Standard Operating Practices on page 5-3.
Table 3-1. Preparation Checklist to Replace a SWAN 2 Concentrator
Step Description
1. Gather the Proper Tools
.
2. Determine the Physical Location of the SWAN 2 Concentrator
.
3. Stop the Communication Lines Using the SWAN 2 Concentrator
.
4. Stop and Reconfigure the SWAN 2 Concentrator
.
5. Label the Communication Cables Connected to the SWAN 2 Concentrator
.
Tool Used to...
Wire cutters Cut cable ties
Utility knife Cut packing tape
Slotted screwdriver Disconnect and reconnect the interface
converter cable to your cable
Torx T-25 screwdriver Loosen and tighten concentrator screws