SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-23
QUEST 2 Command Syntax
At the interactive interface, enter one of the following command statements to
invoke the INFO parameter.
TACL>quest2
-->io
or
-->info
SHOWVPROCS (interactive interface entry mode only)
displays the CLIP, Swan Kernel, Boot file, SNMP, DLC 0/1, and DIAG
VPROCs. This is equivalent to the -io parameter option at the command line
interface. The SHOWVPROCs parameter is only available in the interactive
interface mode.
The command line interface syntax is as follows:
TACL>quest2 -io $systemname.volumename.filename
For example:
TACL>quest2 -io $system.zwandump.D0123456
At the interactive interface, enter one of the following command statements to
invoke the SHOWVPROCS parameter.
TACL>quest2
-->io
or
-->showvprocs
STACKDETAIL
displays the following detailed information about the Stack Frame:
•
Running Task ID
•
Task Name
•
Stack Pointer
•
Cause for the exception
•
Status of DSISR register
•
Values of BAT, IBAT, SR, HID, DAR, and RSR registers
•
SWT status
•
General purpose registers
•
Conditional register
•
Link and Count Registers
•
Instruction pointer (IP), MSR, SSR2, and SSR3 register values