SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-24
QUEST 2 Command Syntax
The command line interface syntax is as follows:
TACL>quest2 -id $systemname.volumename.filename
For example:
TACL>quest2 -id $system.zwandump.S0123456
At the interactive interface, enter one of the following command statements to
invoke the STACKDETAIL parameter.
TACL>quest2
-->id
or
-->stackdetail
STACKFRAME
displays the image of the exception stack if the dump is due to an exception.
The command line interface syntax is as follows:
TACL>quest2 -is $systemname.volumename.filename
For example:
TACL>quest2 -is $system.zwandump.D0123456
At the interactive interface, enter one of the following command statements to
invoke the STACKFRAME parameter.
TACL>quest2
-->is
or
-->stackframe
SWTINFO
displays information to supplement SWT Timeout ISR Dumps. A log gives the
TASK that has taken control and the number of ticks.
The command line interface syntax is as follows:
TACL>quest2 -iw $systemname.volumename.filename
For example:
TACL>quest2 -iw $system.zwandump.D0123456
At the interactive interface, enter one of the following command statements to
invoke the SWTINFO parameter.
TACL>quest2
-->iw
or
-->swtinfo