SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-25
QUEST 2 Command Syntax
SYSFLAGS
decodes the preserved system flags and post run/fail flags.
The command line interface syntax is as follows:
TACL>quest2 -iS $systemname.volumename.filename
For example:
TACL>quest2 -iS $system.zwandump.D0123456
At the interactive interface, enter one of the following command statements to
invoke the SYSFLAGS parameter.
TACL>quest2
-->iS
or
-->sysflags
SWANCT
displays CLIP information (swan_ct and line_ct table information) in readable
form.
The command line interface syntax is as follows:
TACL>quest2 -ic $systemname.volumename.filename
For example:
TACL>quest2 -ic $system.zwandump.D0123456
At the interactive interface, enter one of the following command statements to
invoke the SWANCT parameter.
TACL>quest2
-->ic
or
-->swanct
TASKLONG
provides information for SWAN and SWAN 2 CLIP dumps. In addition to the
information given by the TASKSHORT command, the TASKLONG command
displays the following items for SWAN CLIP dumps:
•
Task ID
•
TCB Pointer
•
User Stack Pointer (USP)
•
Initial USP (IUSP)
For SWAN 2 CLIP dumps, the TASKLONG command displays the following
items in addition to those items from the TASKSHORT command display: