SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-26
QUEST 2 Command Syntax
•
Task ID
•
Task Status
•
Task’s Error Number
•
Initial SSP
•
Task Switch Count
•
Ticks since SWT Service
•
Ticks Since Last Switch
The command line interface syntax is as follows:
TACL>quest2 -iL $systemname.volumename.filename
For example:
TACL>quest2 -iL $system.zwandump.D0123456
At the interactive interface, enter one of the following command statements to
invoke the TASKLONG parameter.
TACL>quest2
-->iL
or
-->tasklong
TASKSHORT
displays a table of information about tasks for SWAN and SWAN 2 CLIP
dumps. This information is provided for SWAN CLIP dumps:
•
TASK NAME
•
FRAME POINTER (FP)
•
SUPERVISORY STACK POINTER (SSP)
•
PROGRAM COUNTER (PC)
•
INITIAL SSP (ISSP)
•
INITIAL PROGRAM COUNTER (IPC)
For SWAN 2 CLIP dumps the following information is displayed:
•
TASK NAME
•
STATUS
•
SUPERVISORY STACK POINTER (SSPL)
•
STACK LOWER ADDRESS (Stk_Low)
•
STACK HIGHER ADDRESS (Stk_High)