SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-30
WANLNCK Command Syntax
•
Verifies all protocol interfaces like RS232, RS449, V35 and X21, and Loopback
connector.
The status of the DIAG and DLC 0 or DLC 1 tasks running in the port to be tested
should be in the STOPPED state.
WANLNCK Command Syntax
The WANLNCK command syntax for:
•
WAN LINE Diagnostic Information Test
•
External Loopback Test on page 5-31
WAN LINE Diagnostic Information Test
The syntax for the WAN LINE Diagnostic Information test is:
Where:
LINE line-name
is a LINE that uses either SWAN or SWAN 2.
DIAG diag-task-filename
is the DIAG task code, which is normally $SYSTEM.CSSnn.DIAG-filename:
Table 5-3. Compatibility between WANLNCK (T0465) and Diag (T8155)
Products
SWAN SWAN 2
T8155AAD
and Pre
T8155AAD
T8155AAE
and Post
T8155AAE
T8155AAD
and Pre
T8155AAD
T8155AAE
and Post
T8155AAE
T0465AAE and Pre
T0465AAE - WANLNCK
(WAN LINE Diagnostic Test)
No changes
in existing
behavior
No changes
in existing
behavior
No changes
in existing
behavior
No changes
in existing
behavior
T0465AAF
and Post
T0465AAF -
WANLNCK
WAN LINE
Diagnostic
Test
No changes
in existing
behavior
No changes
in existing
behavior
No changes
in existing
behavior
No changes
in existing
behavior
External
Loopback
Test
Not
executed*
Executed Not
executed*
executed
* Diag executes the default case and sends an error message to WANLNCK. The reply message is of a
type DIAG2NSK_GEN_ERR and status GEN_ERR_CMD_NOT_REC.
WANLNCK {HELP | LINE line-name [ ,DIAG diag-task-filename ]
[ ,FILE out-put-filename ]}