SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Installing and Using the SWAN Tools
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
5-31
WANLNCK Command Syntax
For SWAN: D8155p00
For SWAN 2: D8155q00
FILE out-put-filename
is a file name to output the result.
For example, see WAN LINE Diagnostic Information Test on page 5-33.
External Loopback Test
The syntax for the External Loopback test is:
Where:
CLIP clip-number
is the CLIP on which the test to be performed:
For SWAN: 1 to 3
For SWAN 2: 1 to 6
TRACKID trackid
is an ADAPTER TRACKID string.
LINENUM line-number
is the port on which the test to be performed:
For WAN X: 0
For WAN Y: 1
TIMES Number of tests
indicates the number of times the test is to be performed. The range is 1 through
150.
DIAG diag-task-filename
is the DIAG task code which is normally $SYSTEM.CSSnn.DIAG-filename:
For SWAN: D8155p00
For SWAN 2: D8155q00
WANLNCK {HELP | TRACKID trackid ,CLIP clip-number
,LINENUM line-number [ ,TIMES Number of tests ]
[ ,DIAG diag-task-filename ] [ ,FILE out-put-filename ]}