SWAN Concentrator and WAN Subsystem Troubleshooting Guide

Troubleshooting Tips for the SWAN Concentrator
and the WAN Subsystem
SWAN Concentrator and WAN Subsystem Troubleshooting Guide—426992-008
6-9
Restarting and Resetting the CLIP Through the
Software
This example shows an EMS message indicating failures on both PATHs (G06.07 and
later RVUs).
This example shows an EMS message indicating failures on PATH A, but successful
on PATH B (G06.07 and later RVUs).
Restarting and Resetting the CLIP Through the
Software
You can restart the CLIP by using the SCF START SERVER command.
1. On a running CLIP, execute the SCF ABORT SERVER command, followed by the
SCF START SERVER command. This action causes a warm and quick restart of
the CLIP.
The lines running on the CLIP will be disturbed but will recover automatically as
soon as the CLIP comes up.
2. If the server was in a STOPPED state, execute the SCF START SERVER
command. Note that, in a multi-system configuration, if the CLIP is controlled by
another system, the START SERVER command will acquire control of the CLIP.
You can execute the WANFBT command, which forces a reboot of the CLIP.
•
This command requires the SERVER to be in a STARTED state.
•
The LINEs running on the CLIP will be disturbed, but will recover automatically as
soon as the CLIP comes up.
•
The WANFBT command will cold reset the CLIP and force the CLIP to run a POST
(Power-On, Self-Test).
ConMgr:
Status Task for Trackid X017R3, Adap
SWAN00.2
Status : FAILED
Path A : No Response from CLIP
Path B : Path Not Configured
Recovery : Retry after a long delay
ConMgr:
Status Task for Trackid X017PW, Adap
SWAN05.3
Status : Successful
Warning : Failed on Path A
Path A : No Response from CLIP